Extend the bpf_fib_lookup() helper by making it to return the source
IPv4/IPv6 address if the BPF_FIB_LOOKUP_SRC flag is set.
For example, the following snippet can be used to derive the desired
source IP address:
struct bpf_fib_lookup p = { .ipv4_dst = ip4->daddr };
ret = bpf_skb_fib_lookup(skb, p, sizeof(p),
BPF_FIB_LOOKUP_SRC | BPF_FIB_LOOKUP_SKIP_NEIGH);
if (ret != BPF_FIB_LKUP_RET_SUCCESS)
return TC_ACT_SHOT;
/* the p.ipv4_src now contains the source address */
The inability to derive the proper source address may cause malfunctions
in BPF-based dataplanes for hosts containing netdevs with more than one
routable IP address or for multi-homed hosts.
For example, Cilium implements packet masquerading in BPF. If an
egressing netdev to which the Cilium's BPF prog is attached has
multiple IP addresses, then only one [hardcoded] IP address can be used for
masquerading. This breaks connectivity if any other IP address should have
been selected instead, for example, when a public and private addresses
are attached to the same egress interface.
The change was tested with Cilium [1].
Nikolay Aleksandrov helped to figure out the IPv6 addr selection.
[1]: https://github.com/cilium/cilium/pull/28283
Signed-off-by: Martynas Pumputis <m@lambda.lt>
Link: https://lore.kernel.org/r/20231007081415.33502-2-m@lambda.lt
Signed-off-by: Martin KaFai Lau <martin.lau@kernel.org>
dab4e1f06c